1-20 ton gas/oil fired boiler

7-70 MW gas/oil fired hot water boiler

2.8-29mw coal fired boiler

horizontal thermal fluid heater

1-20 ton biomass fired boiler

steam generation from eaf – Vertical-steam-boiler …

Application of steam generation from eaf steam generation from eaf in Sugar Mill. Steam is very important for the sugar mill. Steam boiler is used for heating, gelatinization, and saccharify, etc. Heating equipment is equipped under mash kettle, and then steam produced by steam generation from eaf enter into the heating equipment, and then heat the raw materials for starch hydrolysis.

ECS/ WHB solutions - TENOVA

For several applications, e.g. VD plant, a steam network is installed on their premises. In order to reduce primary energy consumption for steam generation TPCO decided to generate steam by waste heat recovery of the hot off gases evolving from EAF#2. To EAF#2 not only scrap is charged but also hot metal (up to 90 %).

Modeling Approach for the Analysis of Energy Recovery

2015-5-12 · Keywords: EAF, electric arc furnace, energy recovery, off gas, ORC, electrical energy generation, steam, process simulation. 1 - INTRODUCTION For industries with energy intensive use the increase of energy efficiency is a relevant target to obtain both scopes of costs production and environmental footprint reduction.

Study of biomass applied to a cogeneration system: A

Coupling waste heat extraction by phase change …

CONTRACTING MODEL TPCO, China - tenova

2017-2-23 · EAF for steam generation in a contracting model. THE PROJECT TPCO (Tianjin Pipe Group Corpo-ration), Tianjin works, operates three Electric Arc Furnaces. For several applications, e.g. VD plant, a steam network is installed on their premis-es. In order to reduce primary energy consumption for steam generation TPCO decided to generate steam

Electric arc furnace - Wikipedia

2019-5-16 · An electric arc furnace (EAF) is a furnace that heats charged material by means of an electric arc. Industrial arc furnaces range in size from small units of approximately one ton capacity (used in foundries for producing cast iron products) up to about 400 ton units used for secondary steelmaking.

Energy Output Through EAF Off-Gas Modelling the EAF …

5 of 20 Increasing energy costs and statutory provisions or incentives leading to increased offers and interest in process control through off-gas measurements and waste heat recovery from EAF off-gas Further investigation of off-gas related questions necessary Optimising the EAF melting process and the EAF …

ECOPLANTS TECHNOLOGIES REVOLUTIONARY …

2014-10-3 · ECOPLANTS TECHNOLOGIES – REVOLUTIONARY CONTINUOUS S/EAF-PROCESS AND INNOVATIVE ENERGY RECOVERY SOLUTIONS BY tions are power generation in steam turbines, driving vacuum pumps, running a EAF will generate an average steam flow of approx. 40 tons per heat at a gauge

Integrated Plant Solutions for Stainless & Special …

EAF WHR System: •Simple & reliable hot water technology •Modular concept Stage 1 = replacement of water cooled hot gas line Stage 2 = replacement of quenching tower •Steam generation from hot water (no steam production within steel plant) •Waste heat utilization for heating, steam production for processing (e.g.: pickling lines)